- 1 What does the bus reset button do?
- 2 How are school bus stops determined?
- 3 What do the three lines on a school bus mean?
- 4 How many amps does it take to start a school bus?
- 5 Do you have to press the stop button on a bus?
- 6 How many miles can a school bus go on a full tank?
- 7 How much room does a school bus need to turn around?
- 8 Why are school buses safer than cars?
- 9 Why do school busses not have seatbelts?
- 10 Do lines on a school bus mean anything?
- 11 Why do some school buses have black hoods?
- 12 How many volts does it take to start a bus?
- 13 How many batteries does a school bus have?
It is a child check button. When the driver turns the bus off at the end of his route, a low tone alarm warning will sound inside the bus. then the driver proceeds to the back of the bus and presses this button to cancel the alarm warning.
How are school bus stops determined?
The Non-Transported areas, less than 2 miles, are determined by measuring the distance, in the most direct route, from the home of the student to the nearest property line of the school of attendance.
What do the three lines on a school bus mean?
The three black rails that run along the sides and back of the bus are called rub rails. Each bus has them and here’s why. First, they’re an extra layer of protection for the thin walls of a school bus. They’ll absorb the force of a collision and a car from caving in the whole side of a bus.
How many amps does it take to start a school bus?
requirements will typically have an electrical load of 80-105 amps, depending on the accessories that each individual operator may choose. However, this same school bus with basic air conditioning, or with 3 50,000 BTU or 2 80,000 BTU under-seat heaters has an average amperage requirement of 160-185 amps.
If stops aren’t announced in your bus, but you know where the stops are, press the stop button soon after passing the last bus stop before your destination. Wait until there is no doubt that you mean the next stop. Some people press the stop button the moment you pass a bus stop, and that creates ambiguity.
How many miles can a school bus go on a full tank?
On average, a clean-diesel school bus can travel about 510 miles on a tank of diesel vs. only 270 miles on gasoline, based on the same standard-sized fuel tanks.
How much room does a school bus need to turn around?
STANDARD 40′ BUS A typical inner turning radius of a standard 40-foot bus is 21.5 feet, which is required to clear the curb. At its tightest turning angle, the rear overhang of the back bumper extends out to 43.3 feet.
Why are school buses safer than cars?
Large school buses are heavier and distribute crash forces differently than passenger cars and light trucks do. Because of these differences, bus passengers experience much less crash force than those in passenger cars, light trucks and vans.
Why do school busses not have seatbelts?
Large school buses are heavier and distribute crash forces differently than passenger cars and light trucks do. Since the sizes and weights of small school buses are closer to those of passenger cars and trucks, seat belts in those vehicles are necessary to provide occupant protection.”
Do lines on a school bus mean anything?
Those black stripes that run along the sides & back of the school bus are actually metal “ rub rails”, and they act as an extra layer of protection for the thin wall panels of the vehicle. Rub rails are placed at very specific spots on the bus body.
Why do some school buses have black hoods?
Hoods painted flat black help to reduce glare. They’re especially helpful this time of year as the sun stays lower in the sky.
How many volts does it take to start a bus?
12.4 volts before you crank.
How many batteries does a school bus have?
The bus is equipped with two batteries.